Evolis Avansia Guía de usuario Pagina 46

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 81
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 45
46
4
Warnings and error messages
LCD Display Description Action required
Cover Open The front cover is open. Yes Close the front cover.
Feeder Empty There are no more cards. Yes Load cards into the card feeder.
Low Temperature The temperature in which the printer is located is too low. Yes
Ensure the environment temperature is
10°C or higher, and press the set Key.
No Ribbon The ink ribbon has been used up. Yes Replace the ribbon or Transfer lm.
Invalid Ribbon The type of ink ribbon cannot be identied by the printer. Yes
Reload the ribbon.
The ribbon set in the printer and printer
settings may be different.
Ribbon Wind Up..
The ink ribbon could not be wound correctly.
The ink ribbon may be cut.
Yes
Reload and wind the ribbon up.
Repair the cut ribbon.
No Film The Transfer lm has been used up. Yes Replace the Transfer lm.
Invalid Film The type of Transfer lm cannot be identied by the printer. Yes
Reload the Transfer lm.
Check what kind of Transfer lm is
supported by the printer.
Film Wind Up..
The Transfer lm could not be wound up.
The Transfer lm may be cut.
Yes
Reload and wind the Transfer lm up.
Repair the cut Transfer lm.
No Ribbon/Film Both ink ribbon and Transfer lm have been used up. Yes
Replace both the ink ribbon and the
Transfer lm.
Feeder Card Jam
Cards cannot be fed into the printer.
Is the card feeder loaded correctly.
The feeding roller is dirty.
Yes
Press the SET Key.
Correctly load the card feeder.
Conrm that the card feeder is loaded
property.
Clean the feeding roller located below
the card feeder.
Flip Card Jam
Printer Card Jam
Mag. Card Jam
There is a card jam. Yes Press the SET Key.
An error ocurred, and cards cannot be output. Yes
Remove the cards by rotating the
ejection dial and press the SET Key.
The feeding roller may be dirty. Yes
Clean the feeding roller.
If the feeding roller is excessively dirty,
clean the printer using a cleaning card.
Vista de pagina 45
1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 80 81

Comentarios a estos manuales

Sin comentarios