Evolis Avansia Guía de usuario Pagina 5
- Pagina / 81
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
5
1-2 Operating the printer safely
The following precautions must be observed to assure safe operation of the printer. Also, do not do anything that is not described in this
manual. Doing so may cause an unexpected accident.
ä
Installing location
Do not install the printer:
l
in a damp or dusty location
l
on an unstable table, on a slant, or any place where there is excessive vibration.
l
in a location susceptible to rapid uctuations in temperature.
l
in a location exposed to direct sunlight.
l
near ammable or explosive materials or heater, stove or other device that produces heat
Place the printer away from walls to maintain air ow. Also, maintain at least 30cm (12") of open space above the printer and at least
15cm (6") on each side on the printer.
Blocking the vents may cause the printer to overheat and catch re.
ä
Power supply
l Use a dedicated power cable and do not use an extension cord with multiple outlets.
l Be sure to remove any dust from the plug and outlet. Humidity produces a micro-current on the surface causing overheating or re.
l Do not damage or modify the Power Cable. Also, do not place heavy objects, pull, or bend excessively.
l Do not plug in or unplug the Power Cable if your hands are wet.
l Ensure a ground wire is connected. When connecting the ground wire, note the following cautions:
l
Recommended connections for ground wires.
- Outlet ground terminal
- Ground terminals installed as type A, B, or C
- A copper rod 65cm (26") or longer buried in the ground.
l
Not permitted for ground wires
- Gas piping (risk of re or explosion.)
- Water pipes or taps (water pipes that include plastic piping cannot act as a ground. However, if a water pipe is
congured to act as a ground, then connection of a ground wire is permitted.)
- Telephone line ground wires or lightning conductors (danger of high current ow in the event of a lightening
strike.)
l Be sure to turn off the power and unplug the plug from the outlet before moving the printer.
l Pull on the plug, not the cable, when unplugging it from an outlet.
l Do not use an under-rated extension cord.
1
- USER GUIDE 1
- Copyright 2
- Copyright notice 2
- Trademarks 2
- Warranty 2
- About your new printer 3
- Warranty registration 3
- Getting started 3
- Contents 3
- Installing location 5
- Power supply 5
- Handling 6
- Security cable 6
- 1-3b INSIDE OF THE TOP COVER 7
- 1-3c REAR SIDE OF THE PRINTER 8
- 1-3d FRONT COVER 8
- 1-4 Installation 9
- 1-5 Installation 10
- 1-5b CONNECTING THE PRINTER 11
- 1-5c RIBBONS AND FILMS 12
- Changing the ink ribbon 13
- Fitting the ink ribbon 14
- Changing the Transfer film 15
- Close the front cover 16
- 1-5d CARDS 18
- Cards orientation 19
- Adjusting card thickness 20
- Loading the cards 21
- Removing printed cards 22
- Rejected card management 24
- Printing 25
- “Card” tab 27
- “Graphics” tab 27
- “Conguration” tab 27
- “Maintenance” tab 27
- 2-3 Printing a card 28
- Maintenance 31
- 3-2 Routine printer cleaning 32
- >> 33
- The adhesive side is 34
- Turn off the printer 36
- Load the card feeder 36
- Decurl Section 37
- Reverse Roller 38
- Flat Screwdriver 40
- 3-8 Cleaning the print head 41
- 4-1a NORMAL MODE 43
- 4-1b USER MODE 44
- 4-2 Warnings and diagnosis 45
- Warnings and error messages 46
- 4-3 Diagnosis help 48
- 4-4 Troubleshooting 49
- Poor print quality? 50
- The card is bent 51
- Print akes off 51
- White cards 51
- Partial or incorrect printing 52
- 4-4b FREEING JAMMED CARDS 54
- Feed slot 55
- Feeding 56
- 4-4c REPLACING THE PRINT HEAD 57
- 4-10 Others functionalities 64
- Short Size Print 65
- Language 65
- 4-11 Technical support 66
- Appendix A 67
- Evolis High Trust 68
- ribbons 68
- Size and weight 70
- Appendix B 71
- Card positioning 72
- bits per inch 73
- Except for the “?” character 73
- Contact station location 74
- Computer connection 78
- Appendix C 79
- (RSS-102) 80
- C1b - FCC REGULATION 81
Relacionado con productos y manuales para Impresión y escaneo Evolis Avansia
Impresión y escaneo Evolis Dualys Guía de usuario
(38 paginas)
(38 paginas)
Impresión y escaneo Evolis Tattoo 2 Guía de usuario
(45 paginas)
(45 paginas)
Impresión y escaneo Evolis Pebble Guía de usuario
(41 paginas)
(41 paginas)
Impresión y escaneo Evolis Zenius Guía de usuario
(63 paginas)
(63 paginas)
Impresión y escaneo Evolis Pebble Guía de usuario
(61 paginas)
(61 paginas)
Impresión y escaneo Evolis TattooRW Guía de usuario
(59 paginas)
(59 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.061 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales