Evolis Avansia Guía de usuario descargar pdf (Pagina 74)

B1b - CONTACT SMARTCARD ENCODING

A printer tted with a smartcard contact station works in exactly the same way as a basic card printer. The Evolis smartcard contact

station is used to program chips to ISO 7816-2 standards.

Contact station location

The contact station is a module tted in the factory. It is located under the ip-over station. To make contact with the station, the smartcard

is pushed into the station. The programming sequence for a smartcard is always carried out before the printing.

Use only smartcards compliant with the ISO 7816-2 standard.

Never print over the chip.

Card positioning

Before loading IC cards, you need to set the orientation of cards.

The factory default setting is [Standard].

Switch from Normal mode to User mode.

Press the t Key until [Card Setup] is displayed. Then press the SET Key.

Press the t Key until [Set card side] is displayed. Then press the SET Key.

Change the settings [Standard] or [Reverse] by using t/s Keys, the press the SEt key.

[Standard] :

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 80 81

Sin comentarios

Evolis Avansia Guía de usuario Pagina 74